Panels · Sheet metal · Insulation · Accessories

How to choose sandwich panels for a building with several operating zones

A workshop, store and cold room can share a building without sharing the same panel specification. Start by mapping the zones. Mark each room's function, temperature and humidity on the floor plan, along with wash-down areas, vehicle entrances and operating equipment. A partition between two zones may have a different job from an outside wall. Note future changes, such as heating part of the store later, so you can distinguish a temporary solution from a permanent one. Only then compare cores, thicknesses and finishes for the conditions in each zone.

By |2026-11-12T21:13:46+01:0012 November 2026|Applications and design|Comments Off on How to choose sandwich panels for a building with several operating zones

How to design a cold room enclosure around actual goods traffic

Two cold rooms at the same temperature may need different enclosures. Door openings, humidity and incoming goods all affect the choice of panel thickness. Plan the walls, floor, doors and refrigeration equipment together. Record the set temperature and what lies on the other side of each surface. A room inside a warehouse faces different conditions from a freestanding outdoor store. A wall bordering a hot production area may have a higher heat gain than the others. For a freezer, include start-up and shutdown conditions in the brief.

By |2026-11-12T20:33:36+01:0012 November 2026|Applications and design|Comments Off on How to design a cold room enclosure around actual goods traffic
Back to top