Panels · Sheet metal · Insulation · Accessories

First-grade or outlet panels: how do you assess them for the intended location?

Judge a panel's grade against the wall or roof where it will be used. A small blemish on a concealed wall has different consequences from a damaged roof joint. Price and appearance alone cannot settle the choice. Start with the project's use, thermal and fire requirements and loads. Match these to the product documents, then assess whether the deviations recorded for the batch are acceptable at the planned location. A scratch on a facing says nothing about whether the other required properties have been confirmed.

By |2026-11-12T21:13:41+01:0012 November 2026|Panel selection and inspection|Comments Off on First-grade or outlet panels: how do you assess them for the intended location?

When does a long 40 mm roof panel in RAL 3009 make sense?

A single panel running from ridge to eaves can eliminate an end lap and the support and sealing detail it would otherwise need. With a panel around 13.5 m long, that benefit has to be weighed against transport, lifting and support requirements. The thin core and dark colour also matter. Before reserving the batch, check whether the roof slope actually matches the length and whether the saving survives the extra site work. Without an end lap the roof still depends on properly detailed side joints, ridge and eaves for weathertightness.

By |2026-11-12T20:52:45+01:0012 November 2026|Panel selection and inspection|Comments Off on When does a long 40 mm roof panel in RAL 3009 make sense?

Will a white 100 mm PIR panel 2.48 m long fit your wall?

A short panel can suit a small room, but first check its length against the plinth and head details. White facings and a 100 mm PIR core describe only part of the product. This example examines a 2.48 m batch, its cutting yield and its condition. The panel length is not necessarily the distance from finished floor to ceiling: the bearing point, base and flashings determine the installation dimension. Identify exactly where the measurement starts and ends. A difference of a few centimetres can rule out the entire batch.

By |2026-11-12T20:52:44+01:0012 November 2026|Panel selection and inspection|Comments Off on Will a white 100 mm PIR panel 2.48 m long fit your wall?
Back to top